Film Washi Leader for Processing”V” and “W” 120 Roll Film

4.08 including VAT

Film Washi 120 Roll Film Leader is needed for the processing of Film Washi’s V and W hand-coated paper 120 Roll Film using classic processing tanks and reels, such as Paterson, Jobo and AP.

These films can also be processed by a careful dip and dunk.

5 in stock

SKU: darkroom-filmwashi-leader-135-1 Categories: , , , , Tags: , , ,

Description

Film Washi Leader for Processing”V” and “W” 120 Roll Film is needed for the processing of Film Washi’s V and W hand-coated paper 120 roll rilm using classic processing tanks and reels, such as Paterson, Jobo and AP.
The principle of this operation is to load the film together with this leader which will guide it onto your developing reel and also protect the film from touching itself during processing.

How to use the leader:
You’ll need a processing reel and tank, this blank plastic leader film and adhesive tape.
This operation must be done in complete darkness for V films but can be done under red light for W films. Tape the end of your film onto the end of the leader stripe. You must position the leader underneath with the film emulsion facing upwards. Insert it inside the reel’s core. In doing so, please ensure the emulsion side is placed inwards and the leader stripe outwards. Load the film as usual but slowly and with extra care.- once you reach the other end of your film, tape it on the leader and finish loading then close the tank as usual.

  • Processing can take place as usual while considering the following points.
  • This procedure needs regular agitation and is not recommended for “stand dev” processes.
  • All hand-coated paper films from Film Washi need to be processed without an acid stop bath, because it could damage the emulsion layer. Please use cold water instead of stop bath.
  • All hand-coated paper films from Film Washi need to rinsed longer than regular ones.
  • While opening your reel, detach the film and separate it from the leader, then inspect your film to check if there are any white spots of unfixed emulsion before drying. If there are then put the film quickly back into the fixer and agitate until all remaining emulsion is fully dissolved then rinse the film again.
  • Clean the leader and hang it up to dry then roll it back on its axis to protect it when not in use. Once the film is correctly washed, it can be dried as usual.

 

The Brownie Camera Guy says:
I absolutely LOVE Film Washi! I use it when I think my subject matter will benefit from the results of the specific film chosen. This film helps the artistic thought process in image making that few other films can.

Additional information

Weight .035 kg

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

You may also like…